Skip to main content Skip to navigation
Purified Mouse IgE, κ Isotype Standard
Product Details
Down Arrow Up Arrow


BD Pharmingen™
dansyl; DNS; 5-[dimethylamino] naphthalene-1-sulfonyl
Mouse C.SW IgE, κ
ELISA Standard (Routinely Tested)
0.5 mg/ml
AB_10050441
Aqueous buffered solution containing ≤0.09% sodium azide.
RUO


Preparation And Storage

The monoclonal antibody was purified from tissue culture supernatant or ascites by affinity chromatography. Store undiluted at 4°C.

Recommended Assay Procedures

Clone 27-74 is useful as a standard in ELISA. Please refer to the Mouse IgE ELISA Protocol below.

MOUSE IgE ELISA PROTOCOL

Coat with Capture Antibody:

1.    Dilute the purified anti-mouse IgE capture mAb (Cat. No. 553413, clone R35-72) to 2 µg/ml in coating buffer.* Add 100 µl per well to an enhanced protein-binding ELISA plate (e.g., BD Falcon™ ELISA Plates, BD Labware Cat. No. 353279).

2.    Shake plate to ensure all wells are covered by capture antibody solution.

3.    Cover the plate and incubate for 1 hour at 37°C or overnight at 4°C.

4.    Wash the plate 3X with PBS/Tween*. For each wash, wells are filled with 200 µl PBS/Tween and allowed to stand at least 1 minute prior to aspirating or dumping. As a final step, tap plate on paper towels to remove excess buffer.

Blocking:

1.    Block the plate with 200 µl blocking buffer* per well.

2.    Cover the plate and incubate at room temperature for 30 minutes.

3.    Wash the plate 3X with PBS/Tween, as in Section I, Step 4, of this protocol.

Apply Standards and Samples:

1.    Leave column 1 as blank wells (i.e., no antigen added, 100 µl per well blocking buffer only). Use columns 2 and 3 for duplicates of the standard, 100 µl per well: dilute purified mouse IgE standard (Cat. No. 557079, clone C38-2; or Cat. No. 553481, clone 27-74) or mouse IgE standard (Cat. No. 557080, clone C48-2) in a series of 8 two-fold dilutions, in blocking buffer, starting at 0.5 µg/ml. Use the remaining columns to add samples at various dilutions in blocking buffer, 100 µl per well.

2.    Cover the plate and incubate for at least 1 hour at room temperature or overnight at 4°C.

3.    Wash the plate 3X with PBS/Tween, as in Section I, Step 4, of this protocol.

Incubation with Detection Antibody:

1.    Dilute biotinylated anti-mouse IgE (Cat. No. 553419, clone R35-118) to 2 µg/ml in blocking buffer. Add 100 µl per well.

2.    Cover the plate and incubate at room temperature for 1 hour.

3.    Wash the plate 6X with PBS/Tween, as in Section I, Step 4, of this protocol.

Add Avidin- or Streptavidin-Horseradish Peroxidase (Av-HRP or SAv-HRP):

1.    Dilute Av-HRP (Cat. No. 554058) or SAv-HRP (Cat. No. 554066) 1:1000 in blocking buffer. Add 100 µl per well.

2.    Cover the plate and incubate at room temperature for 30 minutes.

3.    Wash the plate 6X with PBS/Tween, as in Section I, Step 4, of this protocol.

Add Substrate and Develop:

1.    Thaw substrate (ABTS) buffer* within 20 minutes of use. Add 11 µl of 30% H 2O2 (Sigma, Cat. No. H1009) to 11 ml substrate buffer and vortex. Immediately add 100 µl per well and allow to develop at room temperature for 20 - 30 minutes. Color reaction can be stopped by adding 50µl per well of SDS/DMF Solution* (optional).

2.    Read the plate at 405 nm.

*SOLUTIONS

Coating Buffer                 PBS/Tween                        Substrate Buffer

PBS, pH 7.2 - 7.4                 PBS                                 ABTS (3-ethylbenzthiazoline-6-sulfonic acid, Sigma Cat. No. A-1888) 150 mg

                                        Tween-20 0.05%                 0.1 M citric acid (eg, Fisher anhydrous, Cat. No. A-940) 500 ml

                                                                                Adjust pH to 4.35 with NaOH pellets

                                                                                Aliquot at 11 ml per vial and store at -20°C

PBS Solution                        Blocking Buffer

NaCl 80.0 g                         PBS

Na2HPO4 11.6 g                 Fetal calf serum 10%         SDS/DMF Solution

KH2PO4 2.0 g                 or BSA 1%                         40% SDS (80 g SDS in 200 ml dd H2O)

KCl 2.0 g                                                                 Add 200 ml DMF (N.N-dimethyl formamide)

ddH2O to 10 liter

Adjust pH to 7.2 - 7.4

NOTES

a.   In most cases, coating the plate with primary mAb at 2 µg/ml, 100 µl per well and detecting with the biotinylated secondary mAb at 2 µg/ml, 100 µl per well yields a very satisfactory signal. However, for optimal signal, researchers should titrate each mAb over a range of concentrations (eg, 1 - 8 µg/ml).

b.   Recommended incubation conditions for optimal sensitivity.

c.   Streptavidin/Avidin-HRP conjugate from another supplier may be substituted and diluted according to the manufacturer's recommendation.

Product Notices

  1. Since applications vary, each investigator should titrate the reagent to obtain optimal results.
  2. Please refer to www.bdbiosciences.com/us/s/resources for technical protocols.
  3. Caution: Sodium azide yields highly toxic hydrazoic acid under acidic conditions. Dilute azide compounds in running water before discarding to avoid accumulation of potentially explosive deposits in plumbing.
  4. Sodium azide is a reversible inhibitor of oxidative metabolism; therefore, antibody preparations containing this preservative agent must not be used in cell cultures nor injected into animals. Sodium azide may be removed by washing stained cells or plate-bound antibody or dialyzing soluble antibody in sodium azide-free buffer. Since endotoxin may also affect the results of functional studies, we recommend the NA/LE (No Azide/Low Endotoxin) antibody format, if available, for in vitro and in vivo use.
553481 Rev. 13
Antibody Details
Down Arrow Up Arrow
27-74

The 27-74 monoclonal antibody is specific for the hapten 5-dimethylaminonapthalene-1-sulfonyl (dansyl).

553481 Rev. 13
Format Details
Down Arrow Up Arrow
Purified
Tissue culture supernatant is purified by either protein A/G or affinity purification methods. Both methods yield antibody in solution that is free of most other soluble proteins, lipids, etc. This format provides pure antibody that is suitable for a number of downstream applications including: secondary labeling for flow cytometry or microscopy, ELISA, Western blot, etc.
Purified
553481 Rev.13
Citations & References
Down Arrow Up Arrow
View product citations for antibody "553481" on CiteAb

Development References (1)

  1. Paliard P, Vitrey D, Fournier G, Belhadjali J, Patricot L, Berger F. Perhexiline maleate-induced hepatitis.. Digestion. 1978; 17(5):419-27. (Immunogen). View Reference
553481 Rev. 13

 

Please refer to Support Documents for Quality Certificates


Global - Refer to manufacturer's instructions for use and related User Manuals and Technical data sheets before using this products as described


Comparisons, where applicable, are made against older BD Technology, manual methods or are general performance claims.  Comparisons are not made against non-BD technologies, unless otherwise noted.

For Research Use Only. Not for use in diagnostic or therapeutic procedures.